Getting started
Battery installation and charging
Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset for at least 16 hours before use. When the battery power is low, the handset will beep, display LOW BATTERY and 
will flash on the handset screen. Place the handset in the telephone base or charger to charge the battery when not in use. See the table on page 53 for battery operating times.
If the battery is depleted, it may take approximately four minutes to charge the handset before it can resume screen display. The screen will continue to display LOW BATTERY until the battery has been charged for approximately one hour.
|
|
| Charge | |
|
|
| light | |
1 | 2 | 3 | 4 | 5 |
If the battery | Plug the battery | Place the battery | Align the cover | Charge the handset |
compartment | securely into the | with the label THIS | flat against | by placing it in the |
cover is on the | plug inside the | SIDE UP facing | the battery | telephone base |
handset, press | handset battery | up and the wires | compartment, | or charger. The |
the indentation | compartment, | inside the battery | then slide it | CHARGE light |
and slide the | matching the | compartment. Route | upwards until it | will be on when |
cover to remove. | the wires through | clicks into place. | the handset is | |
|
| the slot at the |
| charging. |
|
| bottom of the battery |
|
|
|
| compartment. |
|
|
•If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.
•To purchase replacement batteries, visit our website at www. vtechphones. com or call
1 (800)
Getting started Basic operation
www.vtechphones.com
