FCC and IC Regulations | FCC and IC Regulations |
This equipmentcomplies with Parts 15 and 68 of the FederalCommunications Commission(FCC) rulesfor the United States. It also complies with regulations RSS 210 and
Alabel is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the 1C registrationnumberand Load Number. You must, upon request, provide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
VTECH COMMUNICATIONS
SERVICE DEPT. at
IN CANADA, CALL VTECH
ELECTRONICS AT 604-273-5131.
For repairlwarranty information. The telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.
FCC Part 15
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal1ation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radiorrV technician for help.
FCC Part 68
The FCC requires that you connect your cordless telephone to the nationwidetelephone networkthrough a modular telephone jack (USOC RJ1IC, RJIIW or RJ14).
Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint with the FCC.
Occasionally,your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the operation of your equipment. If so, you will be given advance notice of the change to give you an opportunity to maintain uninterrupted service.
The base unit contains no user serviceable parts. The handset contains a user replaceable battery pack (see 'REPLACING THE
BATTERIES',page 3).
If it is determined that your telephone equipment is malfunctioning,the FCC requires that it not be used and that it be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructionsoutlined underthe VTECH Limited Warranty.
This equipment may not be used on coin service provided by the phone company or Party Lines.
The REN is useful in determining the number of devices you may connect to your telephone line and still enable the devices to ring when you receive a call. The general rule is that the REN value should not exceed 5.OA total; however, contact your local telephone company for the specific number in your area.
IC (Industry Canada)
This telephone is registeredfor use in Canada. This device complies with
(1)This device may not cause inter- ference, and
(2)This device must accept any interference, including interference that may cause undesiredoperation of the device.
Notice: The lndustry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network, protective, operational and safety requirements. lndustry Canada does not guarantee the equipment will operate to the user's satisfaction.
