MEMORY DIALING

Dialing From Memory

• Press PHONE to get a line.

Press MEM , you're prompted to enter a speed dial location number:

Enter a 2 digit location number (01-20)

The number stored in that location will be displayed and immediately dialed.

Or

Beginning from the OFF mode, press MEM followed by a 2 digit location number (01-20).

Press MEM again to exit memory dial mode and leave the number on the display.

Note that if digits were on the display prior to entering memory dial mode, the contents of the speed dial memory will be ap- pended to those digits. For exam- ple, if 1503 was on the LCD and the contents of the memory location is 6438981, then the display would show the following upon exiting memory dial mode:

NOTE:

The ability to temporarily add memory contents to digits already entered on the display operates in the same way for CID and speed dial memories.

In this way, long distance and area codes (for example, 1503) can be entered on the LCD and can preface numbers recalled from CID memory before dialing. This is important because only the last 7 digits of any number are displayed when dialing from CID memory.

Changing Stored Numbers

To change or replace a stored number simply enter the new number on the display and store it in the memory location you wish to change.

Deleting Stored Numbers

Press MEM . The display will change to "SPEED DIAL LOCATION_ _".

Enter memory location number (01-20).

Press CLEAR/DEL key. The display will change to "LOCATION

XX DELETED".

• Press OFF to exit.

MEMORY DIALING

This inserts a 2 second pause. A

"P " appears in the display to show the pause. For longer pauses, press HOLD two or more times. Each press makes the pause 2 seconds longer and is treated as a stored digit.

If your phone is connected to a PBX, you can store the PBX access number and a pause before the phone number. For example, to store 9-PAUSE-555-1234 in memory location 08, do the following:

1. Press

9

2.Press HOLD

3.Dial 5551234

4.Press PROG

5.Enter 08

NOTE:

Stored numbers are retained in memory even if the base loses its power or the handset battery is removed.

 

 

Storing Special Codes

 

 

To insert a pause in a phone number,

Press

PHONE , the number on

press HOLD at the appropriate point

the display will be dialed after a 2

when entering the number on the LCD.

second

pause.

 

26

27

Page 14
Image 14
VTech VT 1922 Dialing From Memory, Changing Stored Numbers, Deleting Stored Numbers, XX Deleted, Storing Special Codes