GETTING STARTED
SettingUpYourVTECHVT9151/VT9155
1.Choose an area near an electrical outlet and a telephone wall jack.
2.Plug the AC power adapter into an electrical outlet and the DC connector to the back of the base unit.
CAUTION: Use only the AC adapter shipped with your VTECH VT 9151/ VT 9155. This is a Class 2 AC adapter, specifically designed for use with the VTECH VT 9151/VT 9155.
NOTE: Connect power to the base unit before placing the handset in the cradle.
3.The ANSWER ON/OFF indicator key will then turn on to indicate the ITAD is initialized. After a while, the display will show “CL” flashing, indicating that the day and time must be set.
4.CHARGE THE HANDSET BATTERIES BEFORE USE. The batteries recharge automatically whenever the handset is in the base unit cradle. The batter- ies must be charged for 24 hours before using your phone for the first time.
AC
ELECTRICAL
OUTLET
TELEPHONE
WALL JACK
5.Connect the telephone line cord. Insert one end of the telephone line cord into the jack at the rear of the base unit. Plug the other end into a telephone wall jack. Make sure the plugs snap securely into place.
6.CHECK FOR A DIAL TONE. After the batteries are charged, pick up the handset and press the PHONE key. The PHONE indicator should light up, and you should hear a dial tone. If not, see IN CASE OF DIFFICULTY.
CAUTION:
1.Never install telephone wiring during a lightning storm.
2.Never install telephone jacks in wet locations unless the jack is specifi- cally designed for wet locations.
3.Never touch
4.Use caution when installing or modifying telephone lines.
8
