Manuals / Vulcan-Hart / Kitchen Appliance / Fryer

Vulcan-Hart Operation, Over-Temperatureshutdown, Before First Use, Filling Tank With Shortening

Models: 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF ML-136420, 3GR65MF ML-136421, 3GR85MF ML-136422, 4GR45MF ML-136423 1GR35M, 1GR45M, 1GR65M, 1GR85M, 2GR45MF, 2GR65MR, 2GR85MF, 3GR45MF, 3GR65MF, 3GR85MF, 4GR45MF, ML-136407, ML-136408, ML-136409, ML-136410, ML-136417, ML-136418, ML-136419, ML-136420, ML-136421, ML-136422, ML-136423

1 20
Download 20 pages 21.72 Kb
Page 11
Image 11
OPERATION

GR SERIES GAS FRYERS

OPERATION

WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER.

WARNING: SPILLING HOT FRYING COMPOUND CAN CAUSE SEVERE BURNS.

DO NOT MOVE FRYER WITH-

OUT DRAINING ALL FRYING

COMPOUND FROM THE TANK.

WARNING: THE ON-SITE SUPERVISOR IS RESPONSIBLE FOR ENSURING THAT OPERATORS ARE MADE AWARE OF THE HAZARDS OF WORKING WITH HOT OIL, PARTICULARLY OIL FILTRATION, DRAINING, AND CLEANING PROCEDURES.

Note: Do not use chlorine or sulfate/sulfide cleaners.

•Wash any accessories shipped with unit.

•Rinse fryer and accessories thoroughly and drain the fryer. (Open the front door to access the drain valve.)

CAUTION: On fryers equipped with the KleenScreen™ filtering system, do not drain cleaning solution into the pump or filter system. See the KleenScreen™ manual for information on cleaning. Use the Boil-Out-ByPass™ drain extension provided with the KleenScreen™ Fryer. Follow instructions in KleenScreen™ supplemental manual.

•Wipe tank completely dry with a soft, clean cloth.

OVER-TEMPERATURE SHUTDOWN

If the shortening becomes overheated, a high- temperature shutoff device will turn the gas valve off and extinguish the pilot.

If the fryer shuts down due to overheating, DO NOT relight the pilot until the shortening temperature is below 300°F (149°C).

If an overheating situation persists, contact your local Vulcan-Hart authorized service office.

BEFORE FIRST USE

Cleaning

New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the manufacturing process.

•Before any food preparation, thoroughly wash protective oil from all surface parts and the tank interior with hot, soapy water to remove any film residue and dust or debris.

FILLING TANK WITH SHORTENING

Vulcan-Hart requires that liquid shortening be used in all GRM Series Fryers.

AFryer Tank

BMIN and MAX Fill Level Lines

CHeat Pipes

DCold Zone

EDrain Pipe

— 11 —

Page 10 Page 12
Page 11
Image 11
Vulcan-Hart operation manual Operation, Over-Temperatureshutdown, Before First Use, Filling Tank With Shortening, Cleaning
Page 10 Page 12