ASSEMBLING STACKED OVENS
Determine which oven will be on the bottom and place it on its left side, being careful to avoid scratching the finish. Install the four legs, using the 24 bolts and lockwashers provided (6 per leg).
Place lower oven (with legs) on floor. Remove the two 7⁄16" (1.1 cm) knockouts on each side of the top cover and the 13⁄32" (2.8 cm) knockout on the right side of the top cover. Move this oven to the installation position.
Install the two locating studs (included in leg stack set) into the screw plates on the underside of the top oven (Fig. 2) and remove the 13⁄32" (2.8 cm) knockout that will line up with the one removed from the bottom oven. Carefully place the top oven in position above the bottom oven.
LEVELING
Once the oven is in its permanent position, place a carpenter's level on the oven rack. If the oven is installed on legs, turn adjustable feet in or out to level oven
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.
ELECTRICAL DATA
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| NOMINAL AMPS PER LINE WIRE |
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
| TOTAL |
|
|
| 3 PHASE |
|
| 1 PHASE | |||||
|
|
| (KW PER PHASE) |
|
|
|
|
| |||||||
|
|
| KW |
| 208V. |
|
|
| 240V. |
| 208V. | 240V. | |||
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| L1 | L2 |
| L3 | L1 | L2 | L3 | |||||
|
|
|
|
|
|
| |||||||||
| Single Oven | 5.5 | 2.5 | 0 | 3.0 | 23.0 | 10.0 |
| 12.0 | 20.0 | 9.0 | 11.0 | 26.0 | 23.0 | |
| Stacked Oven | 11.0 | 5.0 | 0 | 6.0 | 46.0 | 20.0 |
| 24.0 | 40.0 | 18.0 | 22.0 | 52.0 | 46.0 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Knockouts are provided on the back and bottom of the oven for making conduit connections. Remove the screws from the front control panel for access to the terminal block.
Wire and required hardware for making connections between stacked ovens are furnished with the leg stack set.
Replace the right side panel if it was removed during electrical connection.
Replace the front control panel and turn on the power supply.
– 5 –
