VHX SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
3.To install:
A.On the two replacement descalers, stretch the coiled wire (cathode) at the top to elongate the wire then form an open loop.
B.Hang the descalers on the front horizontal support rod; one to the left of the heating elements and one to the right.
C.Position the descalers so the core (anode) is below the minimum water level in the boiler and hanging freely.
NOTE: To function properly, the descalers must not contact the interior surfaces of the boiler or the heating elements.
COOKING COMPARTMENT
DOOR(S)
Removal
1.Remove top cover.
2.Open the door.
3.Pull hinge rod up.
4.Reverse the procedure to install, making sure the door bushings are in place.
Gasket
1.Open the door.
2.Remove screws from the gasket plate.
3.Pull the gasket plate out from the door housing and remove the gasket.
4.Position the new gasket on the gasket plate and reverse the procedure to install.
5.Adjust the door as outlined in DOOR SEALING ADJUSTMENT under COOKING COMPARTMENT.
NOTE: Do not over tighten gasket plate screws as this will compress the gasket excessively and interfere with proper door sealing.
NOTE: Damage to the gasket sealing surface, such as nicks or cuts, will cause steam leakage.
Handle
1.Open the door.
2.Remove screws from the top and bottom of the door.
3.Pull the inner door panel out from the door housing with the gasket plate and gasket still attached.
F25154 (February 2004) |
| Page 14 of 48 |
|
