Weber 1500 owner manual Install Lid, Add tool holders, control panel and burner control knobs

Step 18

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 30.

Hair pin cotter

Hinge pin

Figure 30

Step 19

Add tool holders, control panel and burner control knobs

You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail and snap down into place. Figure 31.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 31 (a).

Push on the burner control knobs. Figure 31 (b).

	Insert in
Crossover	frame brace
Ignition Button (a)

Control panel push-in buttons

(b)

Tool holders

Figure 31

23