Weber 1500 owner manual Method 4 Wood deck

Step 6

Add front panel and tighten all frame bolts You will need: front panel and two plastic buttons.

Align the panel with the holes in the frame and insert the plastic buttons through the front panel and frame.

Figure 11.

Plastic buttons shown from the rear of the barbecue

Figure 11

Fully tighten the 1/4-20 bolts in the frame assembly, that you only started in Step “Continue Frame Assembly” Figure 12.

Figure 12

Typical installation of the base for an existing concrete patio, new pad or wood deck (continued)

Method 4 - Wood deck

After assembling the base according to the assembly instructions, position the base assembly on your deck for anchoring.

mCAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.

mCAUTION: For a deck installation, it is recommended to anchor one screw into a joist.

Note - With the lid open, the depth of the barbecue is 28 inches, front to back.

Anchor the base to the deck. We recommend using a minimum of a 3/8 inch x 1 1/2 inch lag bolt with a 3/8 inch flat washer. Figure 9.

Note - Use a 3/16 inch drill bit for drilling a pilot hole for a 3/8 inch lag bolt.

3/8 inch x 1 1/2 inch lag bolt

3/8 inch flat washer

Mount plate

Drilled hole

Figure 9

mWARNING: Whichever method used, the base must be bolted down (anchored) at a minimum of four anchoring points (two per side) prior to barbecue assembly. One anchor in each corner of the base plate. Figure 10.

1

4

2

3

Figure 10

16