Weber 55204 manual Install igniter, Gas Catcher Ignition Chamber and the igniter. This

Install igniter		The wire holder (1) is to keep ignition wires from
Note - The igniter wires are already attached to the		interfering with the swing-up table’s bracket. If the wire
Gas Catcher Ignition Chamber and the igniter. This		holder becomes loose, reinstall or replace it
was done to factory test the ignition system.		immediately.
The igniter lock nut is on the igniter.
1)	Loosen the igniter lock nut.
2)	Insert the top of the igniter up through the large
	part of the keyhole in the frame brace. Slide the
	igniter into the small part of the keyhole.
3)	Tighten the igniter lock nut back onto the igniter.
Note - If the igniter works loose, carefully tighten the		(1)
igniter lock nut with an adjustable wrench or pliers.

(1)

(2)

(3)

B-5