![](/images/new-backgrounds/1229574/22957423x1.webp)
Continue frame assembly | Complete frame assembly |
You will need: caster frame, wheel frame, four 1/2 inch | You will need: partial frame assembly, two frame |
bolts, four nylon washers and a 7/16 inch or adjustable | connectors, four 2 inch bolts, four nylon |
wrench. | washers and a 7/16 inch or adjustable wrench. |
Place the caster frame onto the tabs of the left frame, | Hold one frame connector between the caster frame |
so that the swing table locking latch (1) is to the rear. | and wheel frame. Add the nylon washer to the bolt. |
Place the wheel frame onto the tabs of the right frame, | Insert the bolt through the frame and screw into frame |
so that the swing table locking latch (2) is to the rear. | connector. Tighten bolt with wrench. |
The leg tabs must be on the inside of the frames. | Repeat procedure with the other frame connector. |
Add the washers to the bolts. Insert the bolts into the |
|
holes as shown, do not tighten bolts on wheel |
|
frame until a later step. |
|
(1)
(2)