Weber Platinum C manual Installing Work Surfaces, Side Burner Gas Connection Guidelines

Installing Work Surfaces, Side Burner

& Gas Connection Guidelines

Install Left Work Surface		Check that all burner valves are off
You will need left work surface, two 1/2 inch bolts, two		You will need: burner control knobs.
nylon washers and a 7/16 inch or adjustable wrench.		Valves are shipped in the OFF position, but you should
Insert the left work surface tabs in the slots in the		check to be sure that they are turned OFF. Put the
frame(1). Slip washers on the bolts and insert the bolts		knob on each valve. Check by pushing down and
as shown(2). Tighten		turning clockwise. If they do not turn, they are off.
		Proceed to the next step. If they do turn continue
		turning them clockwise until they stop, then they are
(1)	(2)	off. Proceed to the next step.

Install Side Burner Assembly

You will need side burner assembly (assembly in- cludes mounting frame), two 1/2 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench. Note: Remove protective covers from tabs of side burner

Insert the side burner tabs in the slots of the frame(1). Slip washers on the bolts and insert the bolts as shown(2). Tighten bolts with wrench.

(1)(2)

C051.a C-1