31.Attach the end of the Press Cable (109) to a "U'- bracket (50) with an M8 Washer (98) and an M8 Nylon Locknut (91). Note: Do not completely tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset drawing.
32. Locate the Butterfly Cable (106). Grease an M8 | 32 | |
x 22mm Shoulder Bolt (39). Attach the Cable to | ||
| ||
the Left Butterfly Arm (6) with the Bolt and an M8 |
| |
Nylon Locknut (91). Make sure the flat edge of |
| |
the Cable is against the Butterfly Arm. |
|
33. Wrap the Butterfly Cable (106) over a | 33 |
(62). Attach the
34. Wrap the Butterfly Cable (106) under a 90mm | 34 | |
Pulley (63). Attach the Pulley and two Half Finger | ||
| ||
Guards (66) to the Double |
| |
an M10 x 48mm Bolt (84) and an M10 Nylon |
| |
Locknut (90). Make sure the Finger Guards are |
| |
oriented as shown. |
|
35. Wrap the Butterfly Cable (106) over a | 35 | |
(62). Attach the | ||
| ||
(111), an M10 Washer (99), and two Full Finger |
| |
Guards (104) to the Right Upright (2) with an M10 |
| |
x 62mm Bolt (73) and an M10 Nylon Locknut |
| |
(90). |
|
)9.
- 98
50 91
90 106
111
73
104
99 104
106
61
84
_73
104062
99 _ Z lO6
___111' _'_ | @ |
15
