55.Wrap the Ab Cable (107) over a 90mm Pulley
(63). Attach the Pulley and the two Quarter Finger Guards (105) to the Right Upright (2) with an MIO
x 108mm Bolt (72), an M10 Washer (99), and an MIO Nylon Locknut (90). Make sure that the rod
is inserted through both Finger Guards and is over the Cable.
56.]]ghten the Weight Cable (110) into the Weight Tube (not shown) until all the slack is taken out of the cables. Tighten the M12 Nut (49) on the Weight Cable against the M12 Washer (33).
Seat Assembly
57.Attach the Press Backrest (113) to the Backrest Frame (53) with two M6 x 16mm Screws (88), an M6 x 35mm Screw (78), and an M6 Washer (97).
Slide the Backrest Frame (53) into the Left Upright (26). Engage the Knob (43) into the Upright and Backrest Frame, and turn it clockwise until it is tight.
58.Attach a Seat (8) to the Left Seat Frame (27) with four M6 x 16mm Screws (88).
Repeat this step with the other Seat (8) and the Right Seat Frame (not shown).
,11 !
Rod
63
105
72
56
3349
57
,113
58
8
88
88
2O
