Weider 831.159290 user manual End with Two holes Should be Down

CABLE ASSEMBLY

26.Locate one of the pre-assembled pairs of Pulley Plates (31) and 3 1/2” Pulleys (82).

Route the Butterfly Cable (85) under the indi- cated 3 1/2” Pulley (82). The end of the Pulley Plates (31) with two holes should be down- ward. Refer to the inset drawing. Be sure that the Cable is between the Cable Trap

(80)and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.

Tighten the 3/8” x 2” Bolt (50) and the 3/8” Nylon Locknut (not shown).

27.Wrap the Butterfly Cable (85) around a 3 1/2” Pulley (82) as shown. Attach the Pulley and a Cable Trap (80) to the other side of the bracket on the Leg Press Upright (4) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). The

Cable Trap must be oriented as shown and be positioned to hold the Cable in the groove of the Pulley.

28.Note: The Left Arm (6) is shown removed for easier part identification. Slide the other end of the Butterfly Cable (85) onto a 3/8” x 1” Bolt (77). Insert the Bolt through the bracket on the Left Arm (6). Thread a 3/8” Nylon Locknut (42) onto the Bolt, but do not fully tighten it. Leave just enough room for the Cable to pivot.

26
	85
82	50
	End with
	two holes
31	should be
	down
		89
		80
27
	80	50
	42	85
	82
	4
28
	77
	85
	42	6

14