CABLE ASSEMBLY
SEAT ASSEMBLY
56. Wrap the Press Cable (88) around a “V” | 56 | 83 |
|
Pulley (81). Attach the “V” Pulley and a Large |
| ||
|
| ||
Cable Trap (83) to the bracket on the Front |
| 65 |
|
Seat Frame (8) with a 3/8” x 2 1/2” Bolt (65) |
|
| |
|
|
| |
and a 3/8” Nylon Locknut (42). Be sure that |
| 81 |
|
the Large Cable Trap is turned to hold the |
|
| |
|
|
| |
Cable in place and that the Cable and |
|
|
|
Pulley move smoothly. |
|
|
|
|
|
| 8 |
|
| 88 |
|
|
| 42 |
|
57. Note: The 3 1/2” Pulley (82) used in this | 57 |
|
|
step was attached in step 55. It is shown |
|
| |
|
|
| |
removed for easier part identification. |
|
|
|
Route the Press Cable (88) around the 3 1/2” |
|
|
|
Pulley (82). Be sure that the Cable Trap (80) |
| 9 | 43 |
is turned to hold the Cable in place and |
| ||
that the Cable is routed as shown. Tighten |
|
| 82 |
the 3/8” x 4 1/2” Bolt (74) and the 3/8” Nylon |
|
| |
|
|
| |
Jam Nut (43). |
|
| 80 |
|
|
| 88 |
|
| 74 |
|
58. Slide a 5/16” Washer (20) onto a 5/16” x 2 3/4” | 58 |
|
|
Bolt (55). Insert the Bolt into the Front Seat |
|
| |
|
|
| |
Frame (8). Fully tighten a 5/16” Nylon Jam |
|
|
|
Nut (91) onto the Bolt. Slide the end of the |
|
|
|
Press Cable (88) onto the Bolt. Thread anoth- |
|
|
|
er 5/16” Nylon Jam Nut (91) onto the Bolt, but |
|
|
|
do not fully tighten it. Leave enough room |
|
| 88 |
between the two Jam Nuts for the Cable to |
| 8 | |
|
| ||
pivot. |
|
|
|
|
|
| 91 |
|
| 20 |
|
|
| 55 |
|
59. Locate and open the parts bag labeled | 59 | 4 |
|
“SEAT ASSEMBLY.” |
| ||
|
| ||
Attach the Large Backrest (19) to the Leg |
|
|
|
Press Upright (4) with two 1/4” x 2 1/2” |
|
|
|
Machine Screws (64) and two 1/4” Washers |
|
| 19 |
(37). |
| 64 37 | |
|
| ||
23 |
|
|
|
