High Pulley | Weider 831.159290 manual

64.Remove the decals from the decal sheets (not shown) and apply them to the home gym system in the loca- tions shown in the illustration below.

64
	HIGH PULLEY
	BUTTERFLY
AB	ARM
	ARM
	PRESS
	LEG
	PRESS
LEG EXTENSION/CURL
	LOW PULLEY/ROW
SERIAL NUMBER
DECAL

65.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE HOME GYM SYSTEM, beginning on page 26 of this manual.

Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 30 and 31 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING AND MAINTENANCE on page 29.

25

Image 25

Weider 831.159290 user manual High Pulley

Contents

SEARS, Roebuck and CO., Hoffman ESTATES, IL Patent Pending Model No Serial No Full 90 DAY Warranty Table of Contents Important Precautions Before YOU Begin Dimensions Following Tools not Included are Required for Assembly AssemblyFrame ASSEMBLY-PLASTIC Locknuts Do not fully tighten the Nylon Locknuts Nylon Locknuts Fully tighten the Nylon Locknuts Grooves are on the indicated side of each Stack of WeightsLocknut 40. Do not overtighten the Nylon Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet ARM Assembly ARM Assembly ARM Assembly Trap must be oriented as shown and be Find the Butterfly Cable 85-this isPositioned to hold the Cable in the groove Pulley End with Two holes Should be Down Cable Assembly Post Wide Tabs Must be On this Side Cable Assembly Cable Assembly Cable must be routed from the direction shown Find the Press Cable 88. Attach the end Cable Trap is turned to hold the Cable Place Plates 31. The Cable must be routed from Locknut until step Seat Assembly Cable Assembly Seat Assembly Seat Assembly High Pulley Changing the Weight Setting HOW to USE the Home GYM System Adjusting the LEG Press Plate Adjusting the LEG LeverAttaching the AB Strap to the AB Pulley Station Plates Weight Resistance Chart Tightening the Cables TROUBLE-SHOOTING and Maintenance Press Cable High Cable Long U Bracket Leg Press-13 Cable DiagramsButterfly Cable Left Arm Right Arm Page Page X 3 1/4 Bolt Qty Description Part LIST-Model No R0499A Exploded DRAWING-Model No QUESTIONS?