CABLE ASSEMBLY
24.Identify the Rear Cable (86)Ñthis is the shortest Cable. Slide one end of the Rear Cable onto the 5/16Ó x 3Ó Bolt (91) on the Top Frame (2). Thread a 5/16Ó Nylon Jam Nut (90) onto the Bolt. Do not fully tighten the Jam
Nut; leave enough room between the two Jam Nuts for the Cable to pivot.
25.See the inset drawing. Attach a 3 1/2Ó Pulley (82) and a Cable Trap (80) to the upper hole in the Large ÒUÓ Bracket (83) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). Be sure that the Cable Trap is inside the Large ÒUÓ Bracket. Note: This may come
Route the Rear Cable (86) through the Large ÒUÓ Bracket (83) and the 3 1/2Ó Pulley (82).
Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.
26.Wrap the Rear Cable (86) around a 3 1/2Ó Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable must be routed in the direction shown.
27.Attach the Rear Cable (86) to a Small ÒUÓ Bracket (32) with a 1/4Ó Washer (37) and a 1/4Ó Nylon Locknut (44). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.
Attach the Small ÒUÓ Bracket (32) to the indi- cated Weight Tube (25) with a 5/16Ó x 1 3/4Ó Bolt (68) and a 5/16Ó Nylon Locknut (40).
13
24 |
|
|
|
|
| 90 | 91 |
|
|
| |
|
| 86 |
|
|
| 2 |
|
25 |
|
|
|
| 86 |
|
|
| 80 | 82 | 86 |
|
| ||
|
|
| |
| 42 | 50 |
|
|
|
| |
| 83 |
| 82 |
|
| 83 | |
|
|
| |
26 |
|
| 2 |
|
| 42 | |
|
| 50 | |
|
|
| |
|
|
| 82 |
|
|
| 86 |
27 |
|
| 86 |
|
|
| |
|
| 32 | 40 |
|
|
| |
|
| 68 |
|
|
|
| 37 |
|
|
| 44 |
|
|
| 25 |
32 |
| 86 |
|
|
|
| |
|
| 37 |
|
|
| 44 |
|
