CABLE ASSEMBLY
39.Locate the remaining preassembled pair of Pulley Plates (31) and 3 1/2Ó Pulleys (82).
Route the High Cable (84) around the indicat- ed 3 1/2Ó Pulley (82). The end of the Pulley Plates (31) with two holes should be down- ward. Be sure that the Cable is between the Cable Trap (80) and the Pulley, and that the Cable Trap is positioned to hold the Cable in place. Refer to the inset drawing.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon Locknut (not shown).
40.Wrap the High Cable (84) around a 3 1/2Ó Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable must be routed in the direction shown.
41.Attach the High Cable (84) to a Small ÒUÓ Bracket (32) with a 1/4Ó Washer (37) and a 1/4Ó Nylon Locknut (44). Do not completely tighten the Nylon Locknut. It should be threaded onto the Cable enough to be secure; as shown in the inset drawing.
Attach the Small ÒUÓ Bracket (32) to the indi- cated Weight Tube (25) with a 5/16Ó x 1 3/4Ó Bolt (68) and a 5/16Ó Nylon Locknut (40).
42.Lay the Ab Cable (85) over a 3 1/2Ó Pulley
(82).Attach the Pulley and both Pulley Covers
(74)to the Ab Upright (1) with the 3/8Ó x 4Ó Bolt (73), two 3/8Ó Washers (38), and a 3/8Ó Nylon Locknut (42). Make sure that the
Cable is between the Pulley and the post. Do not over tighten the Nylon Locknut; the Pulley should turn easily.
The Pulley Covers (74) must be turned so that the small tabs face away from the training system.
17
39 |
|
|
84 |
| 84 |
50 |
| 82 |
|
| |
31 |
| 80 |
|
| |
End with two |
|
|
holes should |
|
|
be down |
|
|
40 |
|
|
| 42 |
|
2 |
| 50 |
|
| |
|
| 82 |
|
| 84 |
41 |
| 84 |
|
| |
| 32 | 40 |
|
| |
| 68 | 37 |
|
| |
|
| 44 |
84 |
| 25 |
32 |
|
|
37 |
|
|
44 |
|
|
42 |
|
|
42 | 82 Post |
|
38 |
|
|
|
| 73 |
74; Small | 85 | 38 |
tabs must |
| |
be in this |
|
|
location |
|
|
| 1 |
|
