FRAME ASSEMBLY
ARM ASSEMBLY
11.Attach the upper ends of one set of Weight Guides (23) to the Top Frame (2) with a 5/16Ó x 6Ó Bolt (67), two 1/2Ó x 3/4Ó Spacers (69), and a 5/16Ó Nylon Locknut (40). Do not over tighten the Nylon Locknut.
12.Attach the upper ends of the other set of Weight Guides (23) to the Top Frame (2) with a 5/16Ó x 6Ó Bolt (67), two 1/2Ó x 3/4Ó Spacers (69), and a 5/16Ó Nylon Locknut (40). Do not over tighten the Nylon Locknut.
Before continuing, firmly tighten all nylon locknuts used in steps 1 through 12.
13.Locate and open the parts bag labeled
ÒARM ASSEMBLY.Ó
Press a 1Ó x 7/8Ó Plastic Bushing (54) onto each welded spacer on the Press Frame (12). Slide the Press Frame onto the Press Base
(13)so that the Plastic Bushings are aligned with the indicated tube. Note: This will be a tight fit. Make sure that the high pulley is on the side shown.
Lubricate the 3/8Ó x 8Ó Bolt (52). Attach the Press Frame (12) to the Press Base (13) with the Bolt and a 3/8Ó Nylon Locknut (42).
11 |
|
|
|
| 69 |
|
| 40 |
2 |
|
|
|
| 67 |
|
| 23 |
12 |
| 69 |
|
| 40 |
| 2 | 23 |
| 67 | |
|
| |
|
| 23 |
13 |
|
|
|
| Tube |
High |
| 12 |
|
| |
Pulley |
|
|
Welded |
| 13 |
|
| |
Spacers |
| 52ÑLubricate |
|
| |
42 |
| 54 |
|
|
9
