ASSEMBLY
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model 113.241691, From among the loose parts, find the
following Hardware:
24 Truss Head Screws, 1/4 - 20 x 5/8 in. long (top of screw is rounded)
24 Lockwashers. 1/4 in. External Type (approx. dia. of hole 1/4 in.)
24Hex Nuts, 1/4 - 20 (approx, dia. of hole 1/4 in.)
8Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4Leveling feet.
Assemble the legs as shown ...
1.Insert the Truss Head Screws through the holes in the legs, then through the holes in the stiffeners. MAKE SURE THE SCREWS GO
THROUGH THE HOLES IN THE SIDE STIFFENERS MARKED "X".
2. | Install the Iockwashers,.. screw on the nuts but |
| Do Not tighten until completely assembled. |
3, | Install leveling feet. |
o
ASSEMBLE SCREWS
J" THROUGH HOLES
7
"_,SIDE STIFFENER
END
STIFFENER"
_21N. HEX NUTS
MOUNTING SAW
1.From among the loose parts, find the following hardware:
4 Hex Head Screws, 5/16 - 18 x
4 Hex Nuts, 5/16 - 18 (approx. dia. of hole 5/16 in.) 4 Lockwashers, 5/16 in. External Type (approx, dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
2.Place saw on legs so that holes in bottom of saw line up with holes in top of legs.
3, install screws, washers, Iockwashers and nuts as shown.
/
/
/
SAW BASE
HEX HEAD SCREW _,_l I
FLAT WASHER
END;
