MOTOR
LUBRICATmON AND MAINTENANCE
1.The sleeve bearings, in both end shields of the motor, have been lubricated at the factory with correct lubricant. No other part of the motor requires lubrication,
2.
contaminating the oil wicks that supply the bearings with oil. Use a good grade of medium
weight mineral oil, such asautomobileengine oil, SAE 2(3.
3.If disassembly of the motor is necessary, it should be returned to your nearest Sears retail or mail- order store jn order to prevent voiding the
g ua rantee.
NOTE: The speed of this motor canno_ be regulated or changed.
4.Every effort should be made to prevent foreign material from entering the motor. When operated under conditions likely to permit accumulations of dust. dirt, or waste within the motor, a visual
inspection should be made at frequent intervals. Accumulations of dry dust can usually be blown out successfully.
NOTE: Motors used on
;)articularly susceptible to the accumulation of sawdust and wood chips and should be blown out or "vacuumed" frequently to prevent interference with normal motor ventilation and proper
operation of the
MAINTENANCE
WARNING: TO AVOID INJURY, TURN SWDTCH
"OFF" AND REMOVE PLUG FROM | POWER | \ |
| ||
SOURCE OUTLET BEFORE MAINTAINING OR |
| |
LUBRICATING YOUR SAW. |
|
|
Do not allow sawdust to accumulate inside | the saw. |
|
Frequently blow out any dust that may accumulate inside the saw cabinet and the motor.
FrequenUy clean your cutting tools with Craftsman
Gum and Pitch Remover.
A coat of
If the power cord is worn or cut, or damaged in any.i j way, have it replaced immediately.
Make sure the teeth of the ANTIKICKBACK pawls are always sharp. To sharpen:
1.Identify the dull tooth or teeth. Remove blade guard.
2.Rotate pawl toward rear of spreader so that teeth are above top of spreader.
¸¸¸¸38
