Sears 113.241591 owner manual Ploughing And Molding

Feed the workpie'ce by hand along the AUXILIARY FENCE until the end is approx. 1 in. past the front edge of the table. Continue to feed using the PUSH BLOCK.

Hold the workpiece in position and install the PUSH

BLOCK by sliding it on top of the AUXILIARY

FENCE/WORK SUPPORT (This May Raise Guard)-

BAFFLE

Narrow strips thicker than the Auxiliary Fence/Work Support may enter the guard and strike the baffle. CAREFULLY raise guard only enough to clear the workpiece. Use PUSH BLOCK to complete cut.

PLOUGHING AND MOLDING

PLOUGHING is grooving with the grain the long way of the workpiece, using the fence. USE Featherboards and push sticks as required.

MOLDING is shaping the workpiece with the grair

the long way of the workpiece, using the fence. USE Featherboards and push sticks as required.

I

PLOUGHIN

MOLDING

35