
•9. Using a wood block and hammer as shown, move rear support bearing to right or left as req ui red to realign the blade. If necessary, shift front support bearing in similar manner; butdo NOT move front support bearing unless necessary, Recheck the
alignment with the square, then securely retighten all support bearing screws.
NOTE: Be certain that the widest blade you use does not contact blade insert after moving
support bearing. Check this at both 0° (perpendicular to the table) and 45 ° bevel by rotating the fully elevated blade by hand. Readjust as required to maintain sufficient clearance.
WOOD BLOCK
/
BLADE TILT, OR SQUARENESS OF
BLADE TO TABLE
90 ° (SQUARE) and 45 ° (BEVEL) STOP SCREWS.
When the bevel pointer is pointing directly to the "O" mark on the bevel scale, the sawblade should make a SQUARE cut 90° to the table.
To check for SQUARENESS:.
WARNING: TO AVOID INJURY FRONt
ACCIDENTAL START, TURN SWITCH "0 FF" AND
REMOVE PLUG FROM POWER SOURCE OUTLET,
1.Blade should be all'the way UP.
2.Place the square against blade. Make sure square is nottouching the TIP of one of the saw TEETH
O
CLAMP SCREW |
3. Turn the
4.NOTE: Handle is spring loaded for engagement with screw head
// \
12