Sears 113.241591 owner manual TiLT MECHANISM, Mounting The Motor

TiLT MECHANISM

Lower blade to 2 inches or closer to the table top before tilting blade. Failure to do this may result in damage to your saw.

The handwheel should turn freely without binding. The turn ing action can be adjusted by tightening or loosening the screws in the bearing retainer.

NOTE: Tilt Handwheel must be removed to adjust. When adjusting the screws in the bearing retainer

using a screwdriver, hold the nut inside using a 3/8 in. wrench.

TILT HANDWHEEL

_J

ADJUST THESE

TWO SCREWS

MOUNTING THE MOTOR

1.CHECK MOTOR ROTATION

A.The motor must rotate COUNTER-- CLOCKWISE when viewed from the shaft end.

B.MAKE SURE "'KEY" IS REMOVED FROM SHAFT,

C.Place the motor on your workbench or on the floor.

D.Plug the cord into a properly grounded outlet

(See "Motor Specifications and Electrical Requirements" Section.) Notice the rotation

of the shaft. If it is not turning

COUNTERCLOCKWISE, do not continue assembly, Contact your nearest Sears Store or Service Center.

E.Remove plug from outlet.

DIAMETER SHAFT

5/8 INCH

(f

_,._ _"_" KEY

COUNTER-CLOCKWISE

ROTATION

14