If you mount the saw on any other bench, make sure that there is an opening in the top of the bench the same size as the opening =nthe bottom of the saw so that the sawdust can drop through. Recommended working height is 33to 37 inches from the top of the saw table to the floor.
11,1/4
1
OPENING
16"3/4"
15,1
@
7116" DIA,
FRONT Ot: SAW
IMPORTANT -- Read Before Proceeding
Blade cannot be more than 2 inches above the table
top when tilting the sawblade to make bevel cuts or adjustments, Lower blade to 2 inches or closer to the table top to tilt the saw, Failure to do this may result in damage to your saw.
INSTALLING HANDWHEELS
Line up FLAT SPOTS on shaft and handwheel, push handwheel onto shaft. Install screw and Iockwashe r to lOck handwheels on shaft.
CHECKING TABLE INS ERT
1.Insert should be even with table top. Check as shown. Loosen flat head screw that holds insert and adjust the four set screws as necessary, Tighten flat head screw. Do not _ighten screw to the point where it deflects the insert.
2.To remove insert.
A. Loosen Phillips Flat Head Screw.
B:Lift insert from front end, and pull toward front of saw.
3.To replace insert:
Place insert into insert opening in table and push toward rear of sawto engage spring clip and until
keyslot in insert w ! drop over screw T ghten screw.
Do not tighten screw to the point where it will deflect the insert.
.OCKWASHER
| / |
| / |
| |
| PHILLIPS |
ELEVATION | HEAD SCREW |
| |
HANOWB | TILT HANDWHEEL |
//
3/32 IN
SETSCREW WRENCH
/
