5.Removetheplasticcoversfromtheendsof the
SHAFTHOUSING.
6.Push the saw arbor end of the flexible shaft out
of the SHAFT HOUSING until it is
approximately 1 inch above the end of the
SMALL FERRULE.
SAW ARBOR
MOTOR END d | _ | END |
PULL | FLEXIBLE | SAW ARBOR END |
SHAFT | OUT | 1" |
7.Insert the flexible shaft assembly through the opening in the side of the saw base. Line up the SQUARE END of the FLEXIBLE SHAFTwith the
square hole in the arbor shaft, holding square end of flexible shaft insert the FLEXIBLE SHA F]- into the square hole in the arbor as far as it wil I go.
IMPORTANT: Make sure the FLEXIBLE SHAFT is
inserted as far as it will go. Approximately 3/4 inch.
©
L_[
O
SHAFT RETAINER
PAN HEAD SCREW
6
