GETTING TO KNOW YOUR SAW
|
|
| 9 SAWBLADE |
|
| 8 TABLE | INSERT |
MITER | GAUGE | 10 | ANTIKICKBACK |
LOCK | HANDLE |
| PAWLS |
RIP FENCE
HOLES FOR
ATTACHING FACING
6 MITER GAUGE
,,UNOTI TLOOK..EAT,,ABLE,.A"O
2 ELEVATION HANDWHEEL
1
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the blade guard is correctly installed and operating properly.
The
FEATURE IS INTENDED TO PREVENT UNAUTHORIZED AND POSSIBLE HAZARDOUS USE BY CHILDREN AND OTHERS.
A. TO turn saw ON... stand to either side of the blade never in line with it . . . insert finger under switch lever and pull END of lever out.
Do not cycle the motor switch on and off rapidly, as this may cause the sawblade to loosen. In the event this should ever occur. allow the sawblade to come to a cornplete
stop and retighten the arbor nut normally, not excessively. Never leave the saw while the
power is "ON".
B. TO turn saw OFF. . PUSH lever in. Never leave the saw until the cutting tool has come
to a complete stop,
C. TO lock switch in OFF position.., hold switch IN with one hand... REMOVE key with other hand,
WARNING: FOR YOUR OWN SAFETY, LOWER BLADE OR OTHER CUTTING TOOL BELOW TABLE SU RFACE. (IF BLADE IS TILTED, RETURN IT TO VERTICAL (90 ° )
POSITION). ALWAYS LOCK THE SWITCH
OFF. WHEN SAW IS NOT IN USE.. • REMOVE KEY AND KEEP IT IN A SAFE PLACE . . . ALSO . .. IN THE EVENT OF A POWER FAILURE (ALL OF YOUR LIGHTS
GO OUT) TURN SWITCH OFF ... LOCK IT AND REMOVE THE KEY. THIS WILL
PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
\
3 TILT HANDWHEEL
KEY
(YELLOW PLASTIC)
27
