Weider WESY39523 user manual Trap is turned to hold the Cable in the groove of the Pulley

49.Wrap the Swivel Low Cable (72) over a 90mm Pulley (78). Attach the Pulley and a Cable Trap (68) between the lower set of holes in the “U”-bracket (64) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure that the Cable

Trap is turned to hold the Cable in the groove of the Pulley.

50.Attach the end of the Swivel Low Cable (72) inside of the Short Base (2) with an M10 x 65mm Bolt (18), two M10 Washers (91), and an M10 Nylon Locknut (87).

51.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (101) with an M10 x 65mm Bolt (18), two M10 Washers (91), and an M10 Nylon Locknut (87).

52.Wrap the Squat Cable (73) over a 90mm Pulley

(78).Attach the Pulley, a Cable Trap (68), and two 19mm Spacers (98) between the indicated brackets on the Squat Slider (38) with an M10 x 85mm Bolt

(96)and an M10 Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

18

49
100		64
68
		87
72
		78
50
87 91
72	91	18
2
51
	73
		87
		91
		101
91
18
52
68	98
78		87
98
		38
	96
73