61. Turn the Squat Backrest (35) so that the four screw

61

holes are closer to the bottom of the Squat

37

Backrest than the top. Attach the Squat Backrest to

114

the Squat Bracket (37) with four M6 x 16mm

 

Screws (114).

 

Fully tighten the Adjustment Knob (115) into the

114

Squat Bracket (37). Turn the knob on the

35

 

Adjustment Knob counterclockwise several times to

 

loosen it. Next, pull the Knob and slide the Squat

 

Bracket (37) down onto the Squat Slider (38).

 

Engage the Knob into one of the holes in the Squat

115

Slider, and then turn the Knob clockwise until it is

 

tight.

38

62.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on page 25.

21

Page 21
Image 21
Weider WESY39523 user manual