39.Route the Leg Lever Cable (75) under a 115mm Pulley (119). Attach the Pulley and a Large Cable Trap (113) to the indicated side of the Butterfly Upright (3) with an M10 x 95mm Bolt (92), an M10 Washer (91), and an M10 Nylon Locknut (87).

Make sure that the Large Cable Trap is turned to hold the Cable in the groove of the Pulley.

40.Wrap the Leg Lever Cable (75) over a 90mm Pulley

(78).Attach the Pulley to the Double “U”-bracket

(62)with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87).

41.Remove the preattached 90mm Pulley (not shown) from the “U”-bracket (64).

Attach the end of the Leg Lever Cable (75) to the “U”-bracket (64) with an M8 Washer (90) and an M8 Nylon Locknut (34). Note: Do not completely tighten the Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

42.Locate the Swivel Low Cable (72), which is the only remaining cable that has an eyelet on one end and a ball on the other end. Route the eyelet end of the Cable through the cage on the Long Base (101) and through the Swivel Upright (5), as shown. Make sure the Cable is over the short bar inside the cage.

Attach a 90mm Pulley (78) to the indicated bracket on the Long Base (101) with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87). Make sure the Cable is in the groove of the Pulley.

43.Wrap the Swivel Low Cable (72) under a 90mm Pulley (78). Attach the Pulley to the indicated brack- et on the Long Base (101) with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87).

16

39

 

 

 

119

 

92

 

 

113

 

 

 

3

 

 

75

 

 

91

87

40

 

 

 

93

 

 

62

 

 

87

 

 

75

 

 

78

 

41

 

 

64

75

75

90

 

 

 

34

 

 

 

34

42

 

 

78

 

 

72

 

 

Cage

87

 

 

 

101

5

 

93

 

43

 

 

 

72

 

78

 

 

101

87

 

93

 

 

 

Page 16
Image 16
Weider WESY39523 user manual