
CABLE ASSEMBLY
18. Route the Long Cable (23) around the “V”- |
|
|
Pulley (6) on the Right Arm (48). | Be sure | |
that the Cable is in the groove of the “V”- |
| |
Pulley and that the Long Cable Trap (50) | is | |
turned to hold the Cable in place. |
| Tighten |
the 3/8” x 2 1/2” Bolt (7) and the 3/8” Nylon Locknut (not shown).
19.Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut (not shown).
Be sure that the 5/16” x 5” Bolt (68) is proper- ly tightened and that the Pulley Bracket (20) can move freely.
20.See the inset drawing. Attach a 3 1/2” Pulley
(15)and a Cable Trap (66) to the indicated
hole in the Long
2” Bolt (12) and a 3/8” Nylon Locknut (21). Be sure that the Cable Trap is inside the “U”-
Bracket. Note: This may come pre-assem- bled.
Route the Long Cable (23) around the 3 1/2” Pulley (15) and through the Long
21.Note: The 3 1/2” Pulley (15) labeled in this step is
for easy part identification.
Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the bracket on the Top Frame (55). Tighten the 3/8” x 2” Bolt (12)
and the 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.
18 | 50 | 7 |
|
| 6 |
48
23
19 | 68 | 66 |
|
|
20 |
|
12 |
|
23 | 15 |
|
20 |
23 | 23 | |
| ||
66 | 15 | |
12 | ||
|
21 |
57 |
21
23 15
Bracket
12
55 |
21
11