Cable Diagram, Short Cable, Be sure that

CABLE DIAGRAM

The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use the diagram to be sure that the two cables and the cable traps have been assembled correctly. If the cables have

not been correctly routed, the home gym system will not function properly and damage may occur. The numbers show the correct route for each cable. The starting and ending points of each cable are labeled.

the cable traps do not touch or bind the cables.

Long Cable (23)

7—Long “U”-Bracket

Short Cable (58)

Weight Stack—

Be sure that

1—High Pulley

5	2	1—Low Pulley
		1—Low Pulley
4

Page 19

Image 19

Weider WESY85201 Cable Diagram, Cable traps do not touch or bind the cables Long Cable, Short Cable, Be sure that

Contents

Mon.-Fri., 6 a.m.-6 p.m. MST QUESTIONS?Model No. WESY85201 Serial No Customer HOT Line Limited Warranty Table of Contents Ing down Important PrecautionsMake sure that the cables remain on the pul Before YOU Begin Using the Weider Not tighten the Nylon Locknuts yet AssemblyAssembly, use the Part Identification Following Tools not Included are Required for Assembly Each Carriage Bolt Frame AssemblyTighten all Nylon Locknuts used in steps 1 through Shown Frame Assembly ARM Assembly Attach a V-Pulley 6 and a Long Cable Trap On each Arm. Arm identification is very important for stepAttach the Left Arm 47 in the same manner Tighten all Nylon Locknuts used in this step now Nylon Locknuts until the end of this assembly step Cable in place Cable AssemblyLocate the Long Cable A 3/8 Nylon Locknut For easy part identification Pulley 6 on the Right Arm Be sure3/8 x 2 1/2 Bolt 7 and the 3/8 Nylon Locknut not shown Bracket. Note This may come pre-assem- bled Trap 66 is turned to hold the Cable Locate the Short Cable Route3/8 x 3 1/2 Bolt 16 Front Upright Tighten the 3/8 Nylon Locknut 21 and the 3/8 x 3 1/2 Bolt A 1/4 Flat Washer 10. Do not com Cable Assembly Seat AssemblySeat Plate to the Seat 13 with two 1/4 x 1/2 Screws Insert the L-Pin 40 through the holes Seat Assembly Decal Placement8520 Attaching the LAT BAR or Nylon Strap to High Pulley Station AdjustmentChanging the Weight Setting Amount of resistance at each weight station Locking the LEG Lever Weight Resistance Chart That the Cable and Pulley move smoothly TROUBLE-SHOOTING and MaintenanceTightening the Cables Woven cable, the type of cable used on the home Be sure that Cable DiagramCable traps do not touch or bind the cables Long Cable Short Cable Part No R1096A Ordering Replacement Parts WESY85201 R1096A Remove this Part Identification Chart from the Manual Parafusode5/16x13/4 Clipe do Cabo Espaçador de 1/2 x 3/4 61-2 Remove this Part LIST/EXPLODED Drawing from the Manual Qty Description Part LIST-Model No. WESY85201 R1096A

Weider WESY85201 user manual Cable Diagram, Cable traps do not touch or bind the cables Long Cable

Models: WESY85201

CABLE DIAGRAM

the cable traps do not touch or bind the cables.

Long Cable (23)

Short Cable (58)

Be sure that