SEAT ASSEMBLY
DECAL PLACEMENT
32.Press a 1 3/4” Square Inner Cap (44) into the Press Adjustment Tube (79).
Align one set of holes in the Press Adjustment Tube (79) with the holes in the Rocker Arm
(32). Insert the “L”-Pin (40) through the holes.
Be sure that the Press Adjustment Tube is oriented as shown.
Attach the Press Plate (78) to the Press Adjustment Tube (79) with a 5/16” x 2 1/2” Bolt (22), two 5/16” Flat Washers (8), and a 5/16” Nylon Locknut (3).
33.Press a 3/4” Round Inner Cap (34) into each end of the Short Pad Tube (28). Press a 3/4” Round Inner Cap into each end of the Long
Pad Tube (80).
Insert the Short Pad Tube (28) into the Seat
Frame (36). Slide a 5 1/2” Pad (30) onto each end of the Short Pad Tube.
Insert the Long Pad Tube (80) into the Leg
Lever (29). Slide a 5 1/2” Pad (30) onto each end of the Long Pad Tube.
34.Remove the backing from the 8520 decal and apply it to the home gym system as shown.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 16 of this manual.
Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and cor-
rect the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 19 of this
manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See
32 44
79
8 3
8 |
22
40
32 
78
Slant must be turned this way
33 |
34 |
30 |
28
| 36 | 80 | 30 |
|
| ||
|
|
| |
|
|
| 34 |
30 |
|
| 29 |
|
|
|
34
8520
15
