Weider WESY85201 user manual Tighten the 3/8 Nylon Locknut 21 and the 3/8 x 3 1/2 Bolt

CABLE ASSEMBLY

26.Note: The 3 1/2” Pulley (15) labeled in this step is pre-attached. It is shown removed

for easy part identification.

Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the upper hole in the

Press Frame (17). Be sure that the Cable is routed around the Pulley as shown.

Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 1/2” Bolt (16).

27.Note: The 3 1/2” Pulley (15) labeled in this step is pre-attached. It is shown removed

for easy part identification.

Route the Short Cable (58) around the 3 1/2”

Pulley (15) attached to the upper hole in the

Front Upright (42).	Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown.	Tighten the 3/8” Nylon

Locknut (21) and the 3/8” x 3 3/4” Bolt (71).

28. Attach the end of the Short Cable (58) to the

Long “U”-Bracket (57) with a 1/4” Nylon Lock-

nut (2) and a 1/4” Flat Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the

Cable so only a couple of threads are showing above the nut, as shown in the inset drawing.

26

16

9

17

	58
	15
21	66

27

42 58

15 21

9 66

71

28

2

57

10

58

2

10

57 58

13