ARM ASSEMBLY
8.Press a 1 3/4” Square Inner Cap (44) into the top of a Press Arm (46). Wet the handle on
the Press Arm with soapy water. Slide a Handgrip (31) onto the handle. Press a 1” Round Inner Cap (49) into the other end of the handle. Attach the Press Arm to one side
of the Press Frame (17) with two 5/16” x 2 1/2” Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same manner.
9.Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket
on each Arm. Arm identification is very important for step 10.
Attach a “V”-Pulley (6) and a Long Cable Trap
(50)to the Right Arm (48) with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
Attach a
(50)to the Left Arm (47) with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
10.Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 9 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round
8 | 44 |
| |
| 31 |
| 49 |
44
46
49 |
|
46 | 22 |
|
3
17
9 | 50 | 7 | 50 |
| 6 | ||
| 6 |
| |
|
|
|
Welded | 47 |
Brackets | |
| 21 |
48 |
|
10
55
47
Bracket
Lubricate Axle
Cover Cap (70) onto the right axle. Be sure that the teeth on the Retainers bend
toward the Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10” Pad (45) onto the lower end of each Arm.
48
44
45
69
70
55
45
69
70
8
