Parts Drawing | Weil-McLain 550-141-829/1201 guide

Parts Drawing

Image 29

Weil-McLain 550-141-829/1201 manual Parts Drawing

Contents

This Manual Includes Installation Start-Up Boiler Parts When Calling or Writing About the Boiler Symbol DefinitionsRead This Page First Hazard Definitions Table of Contents Installations must comply with Before Installing BoilerBefore selecting boiler location Provide clearances around boiler see Figure Lay a foundation, if needed Provide air for combustion and ventilation Place boiler Install Packaged BoilerTankless heater, if used Perform hydrostatic pressure test Fiberglass wool and ceramic fiber materials Install Non-Packaged Boiler Non-Packaged SGO-3 through 6 position on site Install Non-Packaged Boiler Install burner also refer to instructions packed with burner Install Packaged and Non-Packaged Boiler Install Packaged and Non-Packaged Boiler General chimney requirements Connect Breeching Connect Breeching General piping information Install pipingConnect Steam Piping Connect Steam Piping Connect Steam Piping Condensate Receiver Capacity Table Optional reservoir piping To pipe tankless heater Connect Tankless Heater Piping General wiring requirements Connect WiringThermostat wiring Burner wiring Connect Wiring Low Water Cutoff Wiring Harness not furnished on a Boilers Connect Wiring Boiler Wiring for Probe-Type Lwco Oil piping connection at burner Connect Oil PipingGeneral oil piping requirements Fill the system Start-UpTips for steam systems To place in operation Check off steps as completed Check-Out Procedure To connect SGO boilers to indirect-fired water heaters Burner adjustments for P and a boilersAppendix Parts List Parts Drawing Dimensions Dimensions Dimensions