030-300411 Rev. A 12 July 2004
Westell (Models 6000, 6100, 6110)
User Guide
Figure 1. Connection via 10/100 Base-T Ethernet
NOTE: The modem features shown in Figure 1 apply to the Model 6100 and Model 6110 products. The Model 6000
product has only Ethernet. The power switch is optional for all products discussed in this document.
5.4.2 Installation via USB (Models 6100, 6110)
NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install
via Ethernet connection. See section 5.4.1.
Refer to Figure 2.
1. Connect the power supply cord to the power connector marked ~
on the rear panel of the Modem. Plug the
other end of the power supply into an AC wall socket.
2. Connect the DSL phone cable from the connector marked on the rear panel of the Modem to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must
use the phone cord that was provided with the Modem kit.
3. Connect the blue USB cable from the blue USB connector marked
on the rear panel of the Modem to the
USB port on the PC.
Congratulations! You have completed the USB hardware installation for Models 6100 and 6110. You must now go
to section 6 to begin the USB driver software installation.
12V
!