Westell Technologies 6100, 6000, 6110 manual Check Public LAN Dhcp Settings

User Guide Westell (Models 6000, 6100, 6110)

If you made changes and clicked on save in the preceding screen, the following pop-up screen will be displayed. Click on OK. This will save you Public LAN Configuration settings. If you click on Cancel, your new settings will not take effect.

NOTE: DHCP Lease Time is displayed in the following format: (dd:hh:mm:ss)*. This value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.

*(dd = days, hh = hours, mm = minutes, ss = seconds).

If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warnings messages may be displayed via pop-up screens. If this occurs, check settings in the Public LAN Configuration screen.

Warning Message	Check Public LAN DHCP Settings
Start Address is not part of the Subnet	Check the value in the DHCP Start Address field
End Address is not part of the Subnet	Check the value in the DHCP End Address field
End Address is below the Start Address	Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds	Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 53	Check the Seconds field at DHCP Lease Time
Minutes must be between 0 and 59	Check the Minutes field at DHCP Lease Time
Hours must be between 0 and 23	Check the Hours field at DHCP Lease Time

If you clicked on OK in the Load new Public LAN configuration? screen, the following pop-up screen will be displayed. This will allow the modem to be reset and the new configuration will take effect. Click on OK.

030-300411 Rev. A 64 July 2004