INSTALLATION INSTRUCTIONS
Unpack the Air Conditioner
1.Using the tray back as a template, center in windowsill against outside edge of stool.
WARNING
Excessive Weight Hazard
Use two or more people to move and install air conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
■Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
■Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner.
SMART-MOUNT™ Tray Installation
3
2
1
1.Tray back
2.Windowsill
3.Outside edge of stool
2.Using the 2 inside screw holes in tray back, mark screw locations on windowsill for mounting the
3.Remove tray back. Using these marks, drill ³⁄₃₂ in. pilot holes in the windowsill approximately 1¹⁄₂ in. deep.
4.To assemble the tray frame, insert tab on tray back into slot on tray side. Check to see that the tab is engaged and the 2 pieces are aligned. Insert 2 - #8 - 18 x ¹⁄₄ in.
5.Repeat with other tray side.
3
2
1
1.Tray back
2.#8 - 18 x ¹⁄₄ in.
3.Tray side
5
