Whirlpool 1187361 Position the Air Conditioner, Excessive Weight Hazard, Top view Bottom view

Models: 1187361

1 32
Download 32 pages 19.28 Kb
Page 8
Image 8
Top view

3.Pull curtain toward open end of curtain frame.

4.Insert top and then bottom of right-hand curtain frame in top and bottom curtain guides on air conditioner.

Top view

Bottom view

5.Extend right-hand curtain outward so you may insert the first screw through the middle hole of the curtain. Using a #8 x ³⁄₈ in. pan-head screw, screw curtain to middle hole in air conditioner cabinet.

NOTE: This screw is required to correctly attach curtain (top to bottom) to the air conditioner cabinet.

1

1.#8 x ³⁄₈ in. pan-head screw

6.While the right-hand curtain is still extended, insert screws into top and bottom slots of curtain. Using #8 x ³⁄₈ in. pan- head screws, screw curtain to the top and bottom holes in air conditioner cabinet.

7.Slide curtain housing into guides as far as it will go.

8.Repeat above steps for left-hand curtain.

Position the Air Conditioner

Handle air conditioner with care.

Be sure your air conditioner does not fall out of the opening during installation or removal.

The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded outlet.

Do not block the louvers on the front panel.

Do not block the louvers on the outside of the air conditioner.

Position the Air ConditionerWARNING

Excessive Weight Hazard

Use two or more people to move and install air conditioner.

Failure to do so can result in back or other injury.

1.Put air conditioner on SMART-MOUNTtray. Check that feet on bottom of air conditioner are behind and against back side of windowsill. Lower window sash.

8

Page 8
Image 8
Whirlpool 1187361 manual Position the Air Conditioner, Excessive Weight Hazard, Top view Bottom view