Setting the controls

1.Select ice thickness. The ice maker has been preset to produce ice approximately l/z” (13 mm) thick, while operating in a room temperature of 70°F (21°C).

Operation in different room tempera- tures may require readjusting the control toward “THICK” or “THIN.”

Best operation will be obtained with ice l/z’ (13 mm) to %I’ (16 mm) thick.

If operating in a warm room (above 90°F [32X]) DO NOT set control to maximum thickness or the unit may malfunction.

2.To start the normal ice making cycle, turn the Cycle Control Knob to “ON.”

3.To stop ice maker operation, turn Cycle Control Knob to “OFF.”

The “CLEAN” setting is used whenever solutions are circulated through the ice maker for cleaning. Only the water pump operates at this setting. See “Cleaning the ice maker system” on page 11 for specifii instructions.

Changing the bin door panel

You can easily change the color of the front panel on the storage bin door. Two colors are available: Black and White.

To change panel:

1.Open the storage bin door. Remove the two screws on the top of the door, which hold the handle.

2.Loosen the screws in both of the side trim pieces.

3.Remove the handle and the handle insert.

4.Carefully slide the panel out. You will find the reverse side is white. For units with white panels showing, the reverse side will be black.

5.Choose the color you want to show and carefully slide the panel back into the door.

NOTE: Be careful not to scratch the panel as it is inserted.

6

Page 6
Image 6
Whirlpool 2180633 warranty Setting the controls, Changing the bin door panel