6.Replace the handle insert and tighten the screws in both side trim pieces. Replace the handle and the screws.
NOTE: You can make a decorative wood front to match existing cabinets. The panel
should be l/r* (6 mm) thick and 17” x llV4” (4% mm x 266 mm). Remove the color panel and break off the ribs on the door insulation to allow for wood thickness.
Changing the lower access panel
Electrical Shock Hazard
Do not operate ice maker with lower access panel or control panel removed.
Electrical shock or personal injury could result.
1.Remove the two screws in the lower grille area and the one screw from the center of the front panel support. (Open bin door slightly for better access to screw.) Pull forward and down to remove the lower access panel.
2.Remove the two screws from the top panel trim and remove the top trim.
3.Carefully slide the panel out.
4.Choose the color you want to show and carefully slide the panel back into the lower access panel.
NOTE: Be careful not to scratch the panel as it is inserted.
5.Replace the top trim and screws. Replace the lower access panel assembly and screws.
NOTE: You can make a decorative wood front to match existing cabinets. The panel should be l/4* (6 mm) thick and 17” x 1115/16” (433 mm x 303 mm). Remove the color panel and spacers to allow for wood thickness.
