Vacation and Moving Care Eiectn’cai Shock Hazard
Make sure the ice maker is disconnected
from the main power suppty before
removing lower access panel.
Failure to do so could result in electrical
shock or personal injury.
To shut down the ice maker:
1.
Turn the Cycle Control Knob to “OFF,” and
disconnect electrical power supply to the ice
maker.
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove the two screws in the lower grille
area and the one screw from the center of
the front panel support. (Open bin door
slightly for better access to screw.) Pull
forward and down to remove the lower
access panel.
5. Disconnect the inlet and outlet lines to water
valve. Allow these lines to drain and then
reconnect to the valve.
6. Replace lower access panel and screws.
7. Remove water from drain lines and drain
water pan.
8. Before using again, clean the ice maker and
storage bin.
NOTE:
All components of the ice maker are
permanently lubricated at the factory. They
should not require any additional oiling
throughout the normal life of the machine.