16
Crisper Humidity Control
(on some models)
You can control the amount of humidity in the moisture-
sealed crisper. Adjust the control to any setting between
LOW and HIGH.
■LOW (open) lets moist air out of the crisper for be st
storage of fruits and vegetables with skins.
■HIGH (closed) keeps moist air in the crisper for best
storage of fresh, leafy vegetables.
Door Rails
The door rails may be removed for easier cleaning.

Snap-on Door Rails

To r em ov e t he ra il s:
1. Remove all items from the shelf.
2. Push in slightly on the front of the bracket while pulling
out on the inside tab.
3. Repeat these steps for the other end of the rail.
To replace the rails:
1. Line up the ends of the brackets with the buttons on
the sides of the door liner.
2. Firmly snap bracket and rail assembly onto the tabs
above the shelf as shown.

Drop-in Door Rails

To remove the rails:
1. Remove all items from the shelf.
2. Pull straight up on each end of the rail.
To replace the rails:
1. Slide the shelf rail into the slots on the d oor.
2. Push the rail straight down until it stops.
Door Bins
(on some models)
The door bins are removable for easy cleaning and
adjusting.
1. To remove the bin, simply lift the bin up and pull
straight out.
2. To replace the bin, slide it in above the desired
support button and push down until it stops.
Ice Maker Operation
(on some models)
After the freezer section reaches normal freezer
temperature, the ice maker fills with water and begins
forming ice. Allow 24 hours to produce the first batch of
ice. Ice maker should then produce approximately 7 to 9
batches of ice in a 24 hour-period. Discard the first three
batches of ice produced to avoid impurities that may be
flushed out of the system.
After ice is made, the ice cubes drop into the storage bin.
When ice storage bin is full, ice maker arm raises to the
“OFF” position (arm up). If ice is not needed, you can stop
the ice maker by raising the arm to the “OFF” position (arm
up). Listen for a click sound to be sure that the ice maker
will not continue to operate.