17
To start ice maker, lower arm to the “ON“ position (arm
down). Do not force arm up or down. Do not store anything
on top of the ice maker or in the ice storage bin.
■The ON/OFF lever for the ice maker is a wire signal arm
located on the side of the ice maker. Push the arm
down to start making ice automatically, and push it up
to shut off the ice maker.
■It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
■The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as
overnight.
■If ice is not being made fast enough and more ice is
needed, turn the Freezer Control toward a higher
(colder) number in half number steps. (For example, if
the control is at 3, move it to between 3 and 4.) Wait 24
hours and, if necessary, gradually turn the Freezer
Control to the highest setting, waiting 24 hours
between each increase.
REMEMBER:
■The quality of your ice will be only as good as the
quality of the water supplied to your ice maker.
■Avoid connecting the ice maker to a soft ened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be a voided,
make sure the water softener is operating properly and
is well maintained.
Freezer Shelf(on some models)
To remove the shelf:
1. Lift entire shelf slightly.
2. Move shelf all the way to one side.
3. Tilt other side up and out of shelf supports.
4. Pull shelf up and out.
To replace the shelf:
1. Tilt the shelf and insert into freezer compartment.
2. Insert one end of the shelf all the way into the ce nter of
the shelf supports.
3. Lower other end of shelf and insert into the shelf
supports.
4. Lower shelf into place.
NOTE: The shelf should lower slightly and lock into place.
If the shelf does not appear stable, make sure both ends of
the shelf are inserted into the shelf supports.