Each exhaust duct should enter the maln duct at an angle pointing In the dlrectlon of the airflow. Ducts enterlng from the opposlte side should be staggered to reduce the exhausted air from lnterferlng with the other ducts.
The maxlmum angle of each duct entering the main duct should be nc more than 30”.
Prod?! Damage Keep air openings free of
A
An exhaust hood should cap the outside end of the maln duct to prevent exhausted air from returning to the dryers. If an exhaust hood cannot be used, the outslde end of the main duct should have a sweep
elbow dlrected downward. If the maln duct travels vertlcaliy through the roof, rather than through the wall, Install 180” sweep elbow on the end of duct at least 2 feet above
the hlghest part of the building,
The opening wall or rcof shall have a dlameter l/2 Inch larger than the exhaust duct diameter. The exhaust duct should be centered in the opening.
exhaust;wall hood or
If&
1main exhaust duct
2 ft. min. |
| 180” |
| sweep | |
j vertical duct | ~ | elbow |
| ||
‘highest point |
| i main collector |
‘of building | R | duct |
|
| |
Exhaust duct connectSor:
Electrical Shock t lazard
Disconnect both power supply cords before maklng these changes.
Failure to do so may I esult In electrical shock or personal injury.
I
Determine which directi In you
need to attach the eti rust ducts to the dryers. Both dryers can be exhausted straight out tt be back or from the rlght or left slde The lower dryer can also be exhausted
through the bottom.
Next, determine the leq iih of exhaust duct you will ne ?d to connect the dryers to exhaust hoods or the maln exhal st.
To connect exhau Stduct straight out the ba zk-
Atta exhaust duct
each dryer duct. Then connect exhaust ducts to exhaust hcods or maln exhaust. Use due:! tape to seal all Joints.
To connect exhau? duflc;lttlh~ugh the qht or
I - I\
;“.y4
&zJ-\ \ .\ ‘. ‘. \\ \\
%
2.Remove the duct tape from the Internal exhaust duct and the straight duct. Repeat for the other dryer.
3.Remove the screw from the duct clip that attaches the straight duct to the back of the cabinet. Depress the clip and remove the straight duct using a twisting motlon through the rear exhaust openlng. Repeat for the other dryer.
4.Reach through the rear exhaust
openlng and depress center of tabs on the plastic opening cover cn the side you want to exhaust through.
Remove the cover. Repeat for other dryer.
m=Ql- roof
Do Not install screening or cap over end of duct.
1. Remove access panel by |
|
|
|
|
| ||||
releasing | two locking clip! with a | 5. Attach a three or | |||||||
small, | screwdrib | er. | The | ||||||
elbow to the straight duct using | |||||||||
clips are | located | four inct | es | in from | |||||
duct | tape. | Repeat | with the other | ||||||
each side of the access panel. | |||||||||
elbow | and | straight | duct. | ||||||
|
|
|
|
| |||||
Repeat for other access canel.
Page 7
