Whirlpool 8790 Removing the Side Grilles, Moving the TOP Heating Element Some Models only

REMOVING THE SIDE GRILLES

The accessory-holder grilles are equipped with two fixing screws (fig. 1) for optimum stability.

1.Remove the screws and fixing plates on the right and left with the aid of a coin or tool.

2.To remove the grilles, lift them up (1) and turn them (2) as shown in fig. 3.

Fig. 1 Fig. 2 Fig. 3

MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY)

1.Remove the side accessory holder grilles (Fig. 3).

2.Pull the heating element out a little (Fig. 4) and lower it (Fig. 5).

3.To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral supports.

Fig. 4 Fig. 5 Fig. 6

REPLACING THE OVEN LAMP

To replace the rear lamp (if present):

1.Disconnect the oven from the power supply.

2.Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on.

3.Reconnect the oven to the power supply.

To replace the side lamp (if present):

1.Disconnect the oven from the power supply.

2.Remove the side accessory holder grilles, if present (Fig. 3).

3.Use a screwdriver to prise off the lamp cover (Fig. 7).

4.Replace the lamp (see note for lamp type) (Fig. 8).

5.Reposition the lamp cover, pushing it on firmly until it snaps into place (Fig. 9).

6.Refit the side accessory holder grilles.

7.Reconnect the oven to the power supply.

Fig. 7 Fig. 8 Fig. 9 Fig. 10

N.B.:

-Only use 25-40W/230V type E-14, T300°C incandescent lamps, or 20-40W/230 V type G9, T300°C halogen lamps.

-The lamp used in the appliance is specifically designed for electrical appliances and is not suitable for household room illumination (Commission Regulation (EC) No 244/2009).

-Lamps are available from our After-sales Service.

IMPORTANT:

-If using halogen lamps, do not handle with bare hands since fingerprints can damage them.

-Do not use the oven until the lamp cover has been repositioned.

EN7