EN Operating Your Air Conditioner
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
•If you turn the air conditioner off, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.
•Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up and the air conditioner will not operate properly.
Starting your air conditioner
1. Set the EXHAUST Control (some models) to CLOSED for maximum continuous cooling. The EXHAUST Control set to OPEN position allows you to draw stale or smoky air from the room.
OPEN - to exhaust room air to the outside.
CLOSED - to circulate room air.
The EXHAUST Control will function only when the
FAN CONTROL is operating.
2. Set the FAN CONTROL to the desired setting. | Your air conditioner has one of these controls: |
When the air conditioner is operating at LOW |
|
COOL, MED COOL (some models), or HIGH |
|
COOL, the fan circulates air continuously. |
|
HIGH COOL - for maximum cooling MED COOL (some models) - for normal cooling
LOW COOL - for sleeping comfort
FAN ONLY
When the FAN ONLY setting is selected, the fan will run continuously to move air, but the air will not be cooled.
POWER SAVER (some models)
When the air conditioner is operating on POWER SAVER, the fan runs only when cooling is needed. The fan stops circulating air when the room temperature matches the THERMOSTAT Control setting.
Since the fan does not circulate the room air continuously, less energy is used but the room air is not circulated as often. Use POWER SAVER when you are away from home or asleep.
HEAT/COOL AIR CONDITIONER
HEAT SETTINGS
HIGH HEAT - for maximum heating LOW HEAT - for reducing heating
FAN ONLY (some models) - for circulating air without heating or cooling
5
