1.Unpack mounting parts before installing your air conditioner. Make sure you have all the necessary parts. A normal installation can be made with a screwdriver, saw, small level, pocket knife, tape measure, drill and W: 9/64” and %6” drill bits.
|
|
| Description | of parts |
| ||
|
|
| 1 | Shelf (1) |
|
| |
1 n | back I’I | _ | 2 | Support | bracket | (1) | |
3 | Sill | bracket (1) |
| ||||
|
|
|
| ||||
|
|
| 4 | %6” | bolt | (2) |
|
|
|
| 4A | %” | nut (2) |
| |
|
|
| 48 | %6” | flat washer | (2) | |
|
|
| 4C %6” | lockwasher | (2) |
5Translucent panel (1)
6
6A screw - 10 x 13/4” (2)
7Screw - 8 x 34” (5)
8Side seal strip (1)
9Lower track seal (1)
10Locking bracket (1)
11Foam seal strip (1)
12Panel frame (1)
13Thread cutting screw #% x %” (4)
If using Item 13 for fastening Item 10 or 12 to metal or plastic, use ‘h4” dia. or #28 drill.
2.Pick the right window. First, decide what room(s) you want to cool. Then choose a window that will allow the
The sliding window in which you place your air conditioner should have an opening of at least 15%” wide and 21%” to 40%” high (see diagram). For installations up to 62%” high, a special kit (Part No. 977449) is available. For windows as low as 207/re’: you must install without filler frame and remove top angle on unit, reinstalling 3 screws into top of cabinet.
This model may also be installed in steel hinged casement windows. The steel hinged casement window mUSt have an opening at least 15%” wide and no more than 16%” wide.
3.Place shelf In wlndow with tabs down
against the track surface.